More Christmas Projects

Once I completed the unfinished Honey in the Comb Christmas dishcloth that I'd started last year, I found myself on a roll. I love the vivid colours of holiday yarn, and the untouched skein of Bernat Handicrafter Holidays Ombres Mistletoe in my stash just kept calling out to me.

Mistletoe iCord Necklace
Free pattern (for personal use only).

I started my holiday knitting binge by making iCord necklaces to gift my friends at our annual Christmas party. The necklaces turned out to be very popular.

Materials:

• 1 ball of Bernat Handicrafter Holidays Ombres yarn in Mistletoe Ombre


• preferred tools for making iCord (knitting needles, loom or French Knitting Bee – personally, I prefer the French Knitting Bee)


• tapestry needle


• small Christmas ornaments (I used the handmade glass pendants from a set of wine-glass identifiers)

Instructions:

Create an iCord 26-28 inches long using your preferred method of making iCord.

Sew the two ends of the iCord together and weave in the tails.

On the side of the loop directly opposite where you sewed the ends together, sew on one of your holiday ornaments. Be sure the ornament is heavy enough to hang properly without being so big or heavy that it weighs the neck down.

The example in the photo is a hand-formed glass candy cane.

Tie a piece of contrasting yarn around the sewing to hide it and make a bow to dress up the pendant.

Mistletoe Lily Dish Cloth
I used the free Lily Knitted Dish Cloth pattern from the Dishcloth Boutique. Actually, started it in a Handicrafter Twist, using the 4.5 mm needles called for. I was well into the project before I realized how incredibly wide the dishcloth was turning out. Then I messed up (knitted half of one row of instructions and then the other half of a different row). I only made matters worse when I tried to pick it out, so I unravelled the whole thing. At that point, I decided to change to the Mistletoe yarn, since there seemed to be plenty left in the skein after I finished the iCord necklaces. I also changed to smaller needles (3.25 mm). Finally, I wrote out the instructions in detail (no repeats), so that I could tick everything off as I went and not mix up the row instructions.

Oops. I guessed wrong about the amount of yarn left. I ran short after finishing the pattern, but with 12 rows still to go. I was just about to take apart the last necklace (the friend I’d made it for missed the party) in order to finish the dishcloth, when another friend called out of the thin blue air asking if I wanted to go with her to Walmart (way, way out in the suburbs) that Saturday. Since that’s where the Mistletoe yarn came from, I crossed my fingers and hoped I’d find another ball of it there, so that I could finish the dishcloth without having to undo the necklace… and sure enough, they did! [Happy Dance!]

It came out beautifully, don’t you think? I actually like the reverse side better than the actual front.

Mistletoe Christmas Tree Hot Pad

So, once more I had lots of holiday yarn leftover. This time I decided to do the free Christmas Tree Dish Cloth pattern by Barbara Breiter. To my surprise, when I knitted it up, it was way too small to be a dishcloth despite the pattern’s name and despite using large needles. So, I’ll be using it as a hot pad for holiday dinners.

© 2009-12-27 N0Nightowl

Honey in the Comb Dishcloth

In addition to the Mistletoe Dishcloth that I found in my stored Christmas decorations, I also found a second half-finished dishcloth that I am referring to as "Honey in the Comb" because it's knit using the honeycomb stitch.

Basically, this dishcloth follows the Honeycomb pattern in Sandy Scoville's Knit Dishcloth Sampler (American School of Needlework, publication #1309), except I used two colours instead of one. Why? Because last year I had leftover both mistletoe yarn (from the Mistletoe Dishcloth) and red yarn from a dishcloth that I had done for a friend with a kitchen decorated in red. Neither leftover was enough to make a dishcloth, but the two together produced this lovely Christmas kitchen accessory. I simply used the red for the border in the pattern and the mistletoe for the centre.

I'm still trying to conquer joining two colours cleanly. This was the first time I managed to do it without leaving any holes, but the joins aren’t always clean, plus I made one major booboo. Instead of running the change-over yarn back through the body of the knitting, I accidentally looped it around the outside. Oops! By the time I noticed the problem, I wasn’t in the mood to unravel all my knitting. Since I was doing this dishcloth for me and not as a present for someone else, I decided to leave it as it was.

My Honey in the Comb Dishcloth now makes a striking Christmas decoration hanging above my kitchen sink.

Tasselled and Warm

Free pattern (for personal use only).

A friend gifted me with some lovely silvery-grey yarn, and I knew I had to turn it into a winter hat. I decided to take the basic concept of my pattern for my Demonic Thoughts Tuque and adapt it to something slightly warmer for Canadian winters. The original tuque was done in traditional loom-knitting e-wrap (also known as single stitch), which leaves a somewhat airy result. I’ve since learned that the double stitch produces a tighter, thicker finish.

This hat is incredibly simple to make, but looks quite impressive because of the richness of the boa texture of the brim and the addition of the tassel.

Technique: French Knitting, also known as loom knitting or spooling

Sizes: Small adult (with instructions between brackets for large adult)

Materials:

• Knifty Knitter Round Loom -- green for small-adult size or yellow for large-adult size


• Knifty Knitter Hook


• 1 ball eyelash (boa) variegated yarn (I used a dollar-store generic eyelash yarn)


• 1 ball worsted-weight yarn (this was an unlabelled gift, so I don’t know what brand it was)


• Tapestry needle


• Optional: French Knitting Bee

Instructions:

Step 1: Using a strand each of the eyelash and the worsted-weight yarn held together, e-wrap the loom three times counter-clockwise. There will be three loops on each peg when you are done.

Step 2: Using the hook that came with the loom kit, lift the bottom loop on each peg over the top two loops and over the peg (this is what is meant by "double stitch"). When you have completed the entire circle, you will have two rows of loops remaining on the pegs. Push these loops to the bottom of the pegs.

Step 3: E-wrap the loom. You should now have three loops on each peg once again.

Step 4: Repeat Step 2.

Continue repeating Steps 3 and 4 until your knitting measures 5.5 inches (6.5 inches) long.

Step 5: Cut the boa strand, leaving a 7-8 inch tail, which you will weave in later. Do not cut the two strands of worsted-weight yarn.

Step 6: Pull your knitting through the inside of the loom to access the beginning edge. Place each loop from the originating row over its corresponding peg (hint: start by placing the loop to the right of the original loose yarn over the peg to the right of the outer tie-off peg and continue around the circle counter-clockwise until you have two loops on each peg -- the bottom loop being from the last row you knit and the top loop being from the edge).

Step 7: Lift the bottom loop over the top loop and over the peg. When you have completed the entire circle, you will have one row of loops remaining on your pegs, and the bottom and top of your knitting will have been knit together to form a double-thick brim.

Continue repeating Steps 3 and 4 until your knitting measures 7.5 inches (8.5 inches) beyond the brim. There should be two loops on each peg at this point.

Step 8: Lift the bottom loop over the top loop, so that only one stitch remains on each peg.

Cut your yarn (both strands), leaving 7-8 inch tails.

Step 9: Thread your tapestry needle with a 2- to 2.5-foot length of the worsted-weight yarn. Sew through each loop on the pegs, from bottom to top of the peg. When all loops have been sewn through, join the ends of the sewing yarn with a slip knot.

Step 10: Using the hook, lift all the loops off the pegs. They will now be strung on the yarn you sewed through them with the tapestry needle.

Step 11: Using your favourite technique for creating iCord, make a cord 6.5 (7.5) inches long, leaving a 3-ft. tail on end. Personally, I make my iCords using the French Knitting Bee. However, if you prefer to loom your iCord, click here for video instructions at the Knit Knot Purl Curl website.

Step 12: Make the tassel. Wrap a single strand of the worsted-weight around your hand until you get an amount of yarn that you think would make a nice thickness for your tassel. I wrapped my hand 9 times, which makes an 18-strand tassel. Using a 10-12 inch strand of yarn, tie one side of the loops together with a square knot.

Step 13: Attach the tassel to the end of the iCord with another square knot. Then use the long iCord tail to wrap tightly around the top part of the tassel and the bottom of the iCord. Complete by sewing down through the inside of the wrap and cut off the remaining end of the tail. Cut off the loops at the bottom of the tassel.

Step 14: Turn the hat inside out. Pull the two ends of the sewing yarn together to gather the material for the top of the hat. Before you have completely closed the top, slip through the opening the top end of the iCord.

Step 15: Tighten the sewing yarn until the hole at the top of the hat is completely closed and tie off with a square knot. Then tie one end of the sewing yarn to the tail of the iCord with a square knot. Tie all loose ends of yarn together with one more square knot.

Step 16: Cut the ends of all the yarn tails approximately one inch from the knots. Optionally, you can weave all the tails into the knitting instead of cutting, but I find that it's easier just to leave the short, cut strands as they are on the inside the tuque and cannot be seen.

Step 17: With the tapestry needle, weave in the tails of yarn on the inside of the tuque where the brim joins the top of the hat.

Step 18: Turn your hat right-side-out, and your project is complete.

© 2009-12-08 N0Nightowl

Mistletoe Dishcloth

This year, for the first time ever, I wasn't looking forward to the Christmas holidays -- partially because I can't afford to travel to visit my family thanks to the economy, and partially because I have recently been diagnosed with diabetes, so will not be able to indulge in all the wonderfully delicious seasonal goodies. Determined not to give into depression, I pulled out all the Christmas decorations that I’ve collected over the years and decorated the apartment from top to bottom. The cat ran and hid, terrified I was going to stick a Santa Hat on him...

Among my kitchen decorations, I discovered this beautiful Christmas dishcloth that I had totally forgotten about. Then I remembered that I had started knitting it before Christmas last year but hadn't finished it in time to use during the holidays. So I packed it away, where it languished, unused and ignored, in storage. Now it has the place of honour, hanging above the sink and matching all my holiday-themed potholders, kitchen towels, Santa stove ring covers and vivid red rugs.

This dishcloth was knit using the free pattern for Alex’s Cloth designed by Vaunda Rae Giberson, and using Lily Sugar'n Cream Misletoe cotton yarn.

© 2009-12-07 N0Nightowl